"Singing in the Rain"

A couple days ago we were all discussing the idea of a rain barrel for the garden. I've heard about rain barrels before but have never tried one.... they always seemed rather complicated. Upon doing a little reading up on the matter, this rain barrel project doesn't seem so massive...
Using a rain barrel can actually save you a significant amount of money. For each inch of rain that falls on a 500 square foot roof you can collect 300 gallons of water. That is actually a great deal of water you save and recycle. I'm thinking great for flower pots and houseplants.






  MATERIALS NEEDED
-- 1 large plastic garbage can (the larger it is, the more water you can collect)
-- 1 tube of watertight sealant or roll of Teflon tape for plumbing
-- 2 rubber washers
-- 2 metal washers
-- 1 hose clamp
-- 1 spigot, a drill, and landscape fabric
                                                                              
You don't need a rain barrel kit to conserve water! Start by using your drill to create a hole near the bottom of your barrel. This is where you'll insert your spigot. Use a drill bit that's a little smaller than or the same size as the spigot.
Rain Barrel Hint: Don't create a hole that's too low -- you'll want to leave space underneath to fill your watering can.
Place a metal washer onto the threaded end of spigot, then put a snugly fitting rubber washer over the threads to help hold the washer in place and prevent leakage.
Next, apply a bead of waterproof sealant over your rubber washer and insert the spigot into the hole. Wait for the sealant to dry, then run a rubber washer, followed by a metal washer onto the threads of the spigot inside the barrel. Secure the spigot in place inside your barrel with the hose clamp. This is important because it will keep your spigot from coming loose from your barrel.
Rain Barrel Hint: You can also run watertight Teflon tape to seal the spigot hole.
Carefully cut a hole in the lid of your rain barrel. This hole should sit under your home's downspout so the water runs right into the barrel. Cut the hole so it's large enough to accommodate the water flow from the downspout.
You'll also want to drill a hole or two near the very top of your rain barrel. This hole will allow water to overflow.
Here's a hint: You can run a short length of hose or PVC pipe, from the overflow hole to another rain barrel to connect them. That way if your rain barrel fills, the excess water will run into the next one and you don't lose overflow water.
Cut a piece of landscaping fabric to sit over the top, then put the lid over the top of it to secure it. This will create a barrier that prevents mosquitoes and other pests from getting in your rain barrel water.
Now that the hard work is done, all you have to do is get your rain water barrel in place. Position it directly underneath your downspout in a spot that's most convenient for you to use it. Then just wait for it to rain so you can enjoy the water -- and money -- savings.
Here's a hint: Set your rain barrel up on a platform to help give more pressure if you connect it to a hose. It also makes it easier to fill up watering cans.